Improperly Installed Laminate Flooring
Posted By admin On 01.09.19If the flooring is improperly laid, the warranty will be voided. If any problems arise, stop work immediately and contact your sales representative. Step-by-Step Instructions for Installing Snap-Together Laminate Flooring After making sure that the subfloor is suitable and letting the laminate flooring panels acclimate in the room for at least.
Related Articles
- 1 Disassemble Laminate Flooring
- 2 Easily Remove Old Laminate Flooring From Concrete Floors
- 3 Replace a Laminate Floor Board in the Middle of a Floor
- 4 Remove Floating Laminate to Repair the Subfloor
Laminate flooring comes apart as easily as it goes together, but the edges are fragile, so you have to disassemble a floor carefully if you want to reuse the boards. One of the advantages of laminate flooring is that it floats on the subfloor, which means it isn't attached by glue or nails. When laminates were new, however, you often had to glue the boards to each other, and, once glued, they were difficult to separate. That isn't true of most contemporary laminates. They have a locking mechanism that simply unlocks when you want to separate them.
Pry off the baseboards from the perimeter of the floor and from any posts or other features in the middle of the floor, using a pry bar. The baseboards should be hiding a 1/4-inch gap between the flooring and the wall. You need that gap to begin the disassembly.
Locate the groove-side of the floor, which is the side toward which all the floorboard grooves are facing, by looking in the gap on both sides of the room. In order to separate the boards easily, it's important to pull them toward that side. Start the disassembly in one of the corners on the groove-side.
Place a clean rubber-faced grouting float on top of the corner plank, push down on it, then push the board lengthwise toward the wall. When it disengages from the plank next to it, push it sideways to disengage it from the other plank to which it's attached. Lift it out when it's free of both boards.
Work down that row, removing all the planks that are against the wall in the same way. After removing that row, remove one or two more in the same way so that you have room to stand on the subfloor.
Remove the first plank in the next row by first using the float to disengage the end and then, while standing on the subfloor, lifting the free side about 4 inches off the ground and pulling the plank gently toward you. It should unsnap easily.
Use the lift-and-pull technique to separate all the planks in that row as a unit, then separate them end-from-end with the same procedure.
Things You Will Need
Pry bar
Rubber-faced grouting float
Improperly Installed Laminate Flooring
Tip
Work carefully. Kalloori movie songs free download starmusiq. The locking mechanisms are often made from medium density fiberboard, which breaks easily.
The rubber float may make a black mark on the surfaces of some of the planks. This comes off easily with mineral spirits, which won't damage the hard plastic coating.
If the boards are glued together, the easiest way to separate them is to heat the joints with a heat gun. That may soften the glue enough to separate them. If not, you may just have to pull the boards apart. You won't be able to reuse them in either case.
Warning
Avoid trying to pry the planks apart with a pry bar or screwdriver. Both tools leave noticeable indentations in the edge.
References (1)
About the Author
Chris Deziel has a bachelor's degree in physics and a master's degree in humanities. Besides having an abiding interest in popular science, Deziel has been active in the building and home design trades since 1975. As a landscape builder, he helped establish two gardening companies.
Cite this Article